Installation Guide

• Wipe clean the glass to which the film is to be applied, removing all traces of dirt, grime, grease, etc.
• Precisely measure the height and width of the glass surface. Excess the film up to 3/4“ on each side and cut the film to this size.
• Make wetting solution by mixing 8 drops of very mild detergent with water and fill in a spray bottle.
• Apply a liberal amount of the wetting solution to the glass. This prevents the film from sticking to the surface immediately, thereby providing flexibility to move the film to required position.
• Place the sized film on a clean flat surface with the release liner facing up. Remove the release liner and spray the now exposed adhesive surface thoroughly with the wetting solution.
• Position the now wet film onto the clean glass surface. Wet the face of the film. Use the plastic card squeegee and squeegee from the center out towards the edges to remove any air bubbles and wetting solution. Double check that the film is flat and smooth with no remaining air bubbles and water .
• Still, if any bubbles remain then squeegee them out towards the closest edge.
• Trim the excess film from the edges of the surface. It is ideal to cut in one continuous movement, using the ruler and razor knife. Use the paper towels for cleaning the glass surface and for the absorption of excess wetting solution around the edges.
• Leave the film undisturbed for a few days so that it dries and completely adheres to the glass surface.